Oscillations Formulas

Every Oscillations formula for JEE Main & Advanced, NEET, CBSE, with what each symbol means and when it applies.

Updated11 min read
Formulas
28
Syllabus
Class 11 Physics
For
JEE & NEET
Practise
Chapter PYQs ↗

Oscillations covers periodic motion, and above all simple harmonic motion (SHM), where the restoring force is proportional to displacement. Exam questions ask you to find the time period of a system (springs, pendulums, liquids, tunnels), use the displacement, velocity and energy equations, or combine two SHMs. The fastest route to a period is almost always to write the restoring force as and read off .

On this sheet

Periodic motion

  1. Period, frequency and angular frequency

    These hold for any periodic motion. Use in rad/s inside sine and cosine, not .

    : time period in s; : frequency in Hz; : angular frequency in rad/s.

  2. Period of a sum of periodic functionsJEE

    For example has period . A sum like is not periodic because the ratio of periods is irrational.

Simple harmonic motion

  1. Defining condition of SHM

    Any system whose equation of motion reduces to this form is in SHM with .

    : force constant; : displacement from the mean position.

  2. Displacement

    is equally valid; only the value of changes.

    : amplitude; : phase; : phase constant (initial phase).

  3. Velocity

    Maximum at the mean position; zero at the extremes. Velocity leads displacement by .

  4. Acceleration

    Maximum at the extremes; zero at the mean position. Acceleration is out of phase with displacement.

  5. Period from force or acceleration

    If a problem gives or , read off or and use these. The period does not depend on the amplitude.

  6. Velocity–displacement and amplitude from initial conditions

    The – graph of SHM is an ellipse.

    , : displacement and velocity at .

  7. SHM as projection of uniform circular motion

    The foot of the perpendicular from a particle moving uniformly on a circle onto a diameter performs SHM. Useful for finding the time between two positions.

    : radius of the reference circle; : angular speed of the reference particle.

Energy in SHM

  1. Kinetic and potential energy

    Kinetic energy is greatest at the mean position and potential energy at the extremes. Each varies at twice the frequency of the motion.

  2. Total mechanical energy

    Constant in the absence of damping. Proportional to the square of the amplitude and of the frequency.

  3. Useful energy resultsJEE

    Averages over one period. and each oscillate at twice the frequency of the motion.

Spring systems

  1. Spring–mass system

    Same period for a horizontal or a vertical spring, and on any planet. The period does not depend on the amplitude.

  2. Vertical spring in terms of static extensionJEE

    A vertical spring has the same period as a horizontal one; gravity only shifts the mean position. Use this form when the static extension is given instead of and .

    : extension at equilibrium.

  3. Springs in series and parallel

    A mass between two springs fixed to walls on either side is a parallel combination: .

  4. Cutting a springJEE

    A piece of length has spring constant .

    : length of the original spring; , : lengths of the pieces.

  5. Two bodies joined by a springJEE

    For two blocks on a smooth floor free to move.

    : reduced mass.

Pendulums and other oscillators

  1. Simple pendulum

    Only for small angular amplitude (roughly under 10°). Independent of the mass of the bob. A seconds pendulum ( s) is about 1 m long.

    : length from the point of suspension to the centre of the bob.

  2. Pendulum in an accelerating frameJEE

    In free fall and the pendulum does not oscillate.

    : acceleration of the frame. Lift: when accelerating upward, downward.

  3. Physical (compound) pendulumJEE

    A uniform rod of length pivoted at one end: .

    : moment of inertia about the pivot; : distance from the pivot to the centre of mass.

  4. Torsional pendulumJEE

    Holds for any twist as long as the wire obeys . A thicker or shorter wire has a larger and so a shorter period.

    : torsion constant of the wire (restoring torque per radian of twist).

  5. Liquid in a U-tubeJEE

    Independent of the density of the liquid and of the tube's cross-section, if uniform.

    : total length of the liquid column.

  6. Floating body pushed downJEE

    For a body of uniform cross-section floating upright.

    : depth of the body below the liquid surface at equilibrium.

  7. Body in a tunnel through the earthJEE

    Same for any straight smooth tunnel through a uniform earth, through the centre or not.

    : radius of the earth.

Combining two SHMs

  1. Two SHMs of the same frequency along one lineJEE

    The result is an SHM of the same frequency. Add them like vectors (phasors).

    : phase difference between them; : phase of the result relative to the first.

Damped and forced oscillations

Damped and forced oscillations are qualitative in the current NCERT; the equations below are used in JEE.

  1. Damped oscillationJEE

    Amplitude decays exponentially; damping also lowers the frequency slightly.

    : damping constant (damping force ).

  2. Energy of a damped oscillatorJEE

    Energy falls twice as fast (in the exponent) as amplitude because .

  3. Amplitude of forced oscillationJEE

    Resonance: amplitude peaks when for light damping. Less damping gives a taller, sharper peak.

    , : amplitude and angular frequency of the driving force; : natural angular frequency.

Common mistakes

Use these formulas on real questions

Every Oscillations question from the official papers, sorted by chapter.

Questions about Oscillations formulas

What is the formula for the time period of a simple pendulum?

, where is the length to the centre of the bob. It holds for small angles and does not depend on the mass of the bob or the amplitude.

How do you find the time period of any SHM?

Displace the body by a small , write the restoring force or torque, and bring it to the form (or ). Then and .

At what displacement are kinetic and potential energy equal in SHM?

At , about 0.707 of the amplitude. Each is then half the total energy.

Are damped and forced oscillations in the NEET syllabus?

Only as ideas. The current NCERT and NEET syllabus discuss damping and resonance qualitatively. The equations for damped amplitude and forced amplitude are marked JEE on this page.

More Physics formula sheets